Описание

  • Also suitable for glossy and reflective objects
  • Condition monitoring
  • High switching frequency
  • IO-Link 1.1
  • No blind spot from single-lens optics
The retro-reflex sensor works with red light and a reflector. It also reliably detects objects with reflective or glossy surfaces at high speeds. Thanks to its great range, the sensor can, for example, be used to manage feed and presence controls as well as to detect objects on wide feed belts. The IO-Link interface can be used to configure retro-reflective barriers (PNP/NPN, NC/NO, switching distance), as well as for reading out switching statuses and signal values.
Range 7000 mm
Reference Reflector/Reflector Foil RQ100BA
Min. Distance to Reflector 0 mm
Smallest Recognizable Part see Table 2
Switching Hysteresis < 15 %
Light Source Red Light
Polarization Filter yes
Service Life (T = +25 °C) 100000 h
Max. Ambient Light 10000 Lux
Light Spot Diameter see Table 1
Single-Lens Optic yes
Electrical Data
Supply Voltage 10...30 V DC
Supply Voltage with IO-Link 18...30 V DC
Current Consumption (Ub = 24 V) < 20 mA
Switching Frequency 2000 Hz
Switching frequency (speed mode) 3500 Hz
Response Time 0,25 ms
Response time (speed mode) 0,14 ms
Temperature Drift < 10 %
Temperature Range -40...60 °C
Switching Output Voltage Drop < 2 V
Switching Output/Switching Current 100 mA
Residual Current Switching Output < 50 µA
Short Circuit Protection yes
Reverse Polarity Protection yes
Overload Protection yes
Interface IO-Link V1.1
Protection Class III
Mechanical Data
Setting Method Potentiometer
Housing Material Plastic
Degree of Protection IP67/IP68
Connection M12 ? 1, 4-pin
Optic Cover PMMA
Safety-relevant Data
MTTFd (EN ISO 13849-1) 2394,2 a
Output
IO-Link yes
PNP NO/NC antivalent yes
''